X Chair

The X-Chair is an easy-to-use ferrule chair, developed to locate ‘near-face’ ferrules in precast and tilt-up panels. The uniquely designed X- Chair accommodates all standard PSA X- Foot and Round 96mm high ferrules. The X-Chair will cater to most third party (non PSA) round ferrules.

The design has an in-built cross support and integral centre spigot to accurately position the ferrule to shop drawing locations.

The X-Chair is designed to locate a 96mm ferrule at 2mm below the panel surface. Manufactured in light grey, coloured plastic; providing a strong, impact resistant support, which is non-corrosive and has small dimpled feet to provide minimal exposure. The X- Chair locates the 96mm ferrules at the correct height only when the compulsory ‘omega bar’ is used. The ‘omega bar’ has the option of being placed through the ferrule, then inserted and clipped onto the chair. Alternatively the omega bar may be pushed through the ferrule (when already sitting within the pre-positioned chair) with the bar then coming to rest on the alternate platform, without the use of the clip.

Custom heights may be accommodated, subject to volume orders.

X Chair
  •  
  • X Chair - XC125

    XC125
    125mm X Ferrule Chairs
    Unit Type
    Add to Favorites
  • X Chair - XC150

    XC150

    150mm X Ferrule Chairs

    Unit Type
    Add to Favorites
  • X Chair - XC175

    XC175

    175mm X Ferrule Chairs

    Unit Type
    Add to Favorites
  • X Chair - XC180

    XC180

    180mm X Ferrule Chairs

    Unit Type
    Add to Favorites
  • X Chair - XC200

    XC200

    200mm X Ferrule Chairs

    Unit Type
    Add to Favorites
  • X Chair - XC250

    XC250

    250mm X Ferrule Chairs

    Unit Type
    Add to Favorites
  • X Chair - XCDP

    XCDP

    Locating Dowel pin to suit X-Ferrule Chair

    Unit Type
    Add to Favorites